Polyurethane injection system

Standard figuration

1. Mainsystem:1 set

Including material pump system , cleaning pump system , double component material feeding system , control system and etc ; double component material feeding  system  includses A&B raw material tank , back flow and material checking and control assembly.

2. High and low temperature circulator 1 setOptional,auxiliary control for constant temperature of system raw material

3. Material feeding pump or self feeding system:1 groupOptional,material :feeding pump (3G-63)

4. ancillary perfusion gun :1 piece

5. Operation panel for gun :1 piece

6. Insulated pipe: 1 group

7. Auxiliary piping and joints : 1 set

Technical parameters

1. raw material ratio：            1:1-1:5（or any other requirement ）

2. Raw material flow MAX：         50-2400ml/min

3.Viscosity range of raw material：        200~1000CPS（operating temperature）     

4. Air pressure：            0.5~0.8Mpa（70~120psi）≥0.8m3/min

5.system power requirement ：        Three-phase five line 380V 50HZ  25A×3

6.low temperature circulato：      2500W (or option ）

7.temperature control range         ：  25℃~55℃

8.tubular holder group length：        8m or option

9. pressure of system raw material ：        ≤4Mpa（570psi）or ≤7Mpa（1000psi）

10. Pressure for cleaning pump system：      ≤2.1Mpa（300psi）

11. Features of perfusion gu：         pneumatic, on-off controlled by handle,   automatic back flow when gun off

12.Mixing mode for perfusion gun:  initial collision + static mixer：   Air inlet pressure for perfusion gun  

13.Air inlet pressure for perfusion gun：  0.5~0.8Mpa（70~120psi）

 Air pipe size：            φ8×1

14.Cleaning method for perfusion gun work methood：      0~12Kg/min

15.Cleaning method for perfusion gun：    sequential combination with fluid cleaning + air cleaning (or select single cleaning method)